Search the Community

Showing results for tags 'Nuts Square Nuts'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • General Boating Discussion
    • Boat Topics and Questions
    • Bottom Paint Discussions
  • Product Categories
    • Abrasives
    • Anchoring and Docking
    • Apparel
    • Cleaning and Polishing
    • Electrical
    • Electronics
    • Engine Room
    • Epoxy and Adhesives
    • Fasteners
    • Fiberglass Supplies
    • Fishing Tackle
    • Gifts and Books
    • Hand Tools
    • Hardware
    • Marine Supplies
    • Paints
    • Paint Supplies
    • Plumbing
    • Power Tools
    • Storage / Organization
    • Safety
    • Tapes
    • TotalBoat Products
    • Trailer Parts
    • Varnish - Frequently Asked Questions
    • Wood, Foam, Starboard

Found 1 result

  1. Where can I get the #8-32 Chris Craft "PM" (Press Metal) nuts they used to secure the lapstrake siding on the 60's vintage boats? These are approximately 3/8" square (.490" measured) silicone-bronze material, .050" thick with a shallow curve and the corners slightly bent down to bite into the wood to prevent rotation. It is possible they were just stamped with a punched hole and a self tapping screw was used. The inside of the screws are cut off to be flush with the nut after it was tightened so I can't tell if it was a thread cutting screw or not.