Search the Community

Showing results for tags 'canoe'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • General Boating Discussion
    • Boat Topics and Questions
    • Bottom Paint Discussions
  • Product Categories
    • Abrasives
    • Anchoring and Docking
    • Apparel
    • Cleaning and Polishing
    • Electrical
    • Electronics
    • Engine Room
    • Epoxy and Adhesives
    • Fasteners
    • Fiberglass Supplies
    • Fishing Tackle
    • Gifts and Books
    • Hand Tools
    • Hardware
    • Marine Supplies
    • Paints
    • Paint Supplies
    • Plumbing
    • Power Tools
    • Storage / Organization
    • Safety
    • Tapes
    • TotalBoat Products
    • Trailer Parts
    • Varnish - Frequently Asked Questions
    • Wood, Foam, Starboard

Found 1 result

  1. Fiberglass canoe project with hole in bottom - need advice I took on this project; there is hole near the front in center, it's about a 12" gash, (keel if a small ridge can be called that), looks like it has been repaired once before, on inside has a blister (delam I guess). (I'll get some pics up soon so u can see damage both sides) Obvious Ques.: polyester or epoxy resin? Gelcoat and gelcoat color? It's already 2 shades of yellow is painting a good idea, is there special paint? *Would spruce be good substitute for mahogany gunwales from standpoint of bending to follow curve and holding screws? I've heard finish should be Not varnish but oil? I've seen boats with some kind of standoff interior gunwale, is this about having continuous tie down points? My pics are over the limit - It's a no name 16' x 32" canoe, has 2 wooden seats and yoke attached at gunwales.