• Announcements

    • skiptabor

      The future of the JD Forum   07/31/18

      Thank you all for your participation on the JD Forums.  We have enjoyed answering your questions, providing project advice and technical assistance on this forum for a number of years. We believe that there are now better ways to provide this service for our customers and the community. With that in mind, we have made the difficult decision to discontinue the Jamestown Distributors Forum.   Our JD Tech Team is committed to being your trusted technical resource, and we encourage you to reach out via email, phone, social, product reviews, and to post questions using the Q & A 'Ask A Question' function on all product pages. Additional information can also be found on product page Technical Data Sheets (including detailed usage instructions and application data).   Thank You Jamestown Distributors 

Search the Community

Showing results for tags 'correct ccr mistakes'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • General Boating Discussion
    • Boat Topics and Questions
    • Bottom Paint Discussions
  • Product Categories
    • Abrasives
    • Anchoring and Docking
    • Apparel
    • Cleaning and Polishing
    • Electrical
    • Electronics
    • Engine Room
    • Epoxy and Adhesives
    • Fasteners
    • Fiberglass Supplies
    • Fishing Tackle
    • Gifts and Books
    • Hand Tools
    • Hardware
    • Marine Supplies
    • Paints
    • Paint Supplies
    • Plumbing
    • Power Tools
    • Storage / Organization
    • Safety
    • Tapes
    • TotalBoat Products
    • Trailer Parts
    • Varnish - Frequently Asked Questions
    • Wood, Foam, Starboard

Found 1 result

  1. I used CCR to make a casting and ended up with some bubbles (thought the surface was completely sealed but I must’ve missed a couple of spots). I’ve been doing research on fixing it and found suggestions to sand down past the bubbles, sand the whole surface and reapply a thin coat. Haven’t found anyone doing this with Entropy’s resins specifically, or CCR-like products. Mostly with resins meant for thin coatings (e.g.: ArtResin). I’m curious if anyone has tried anything like this or if anyone knows whether this method would not work with this product. If not, what's the best approach to fixing trapped bubbles? Should I use the super sap one instead of the ccr to apply a thin coat after sanding? Thanks,Steve