Search the Community

Showing results for tags 'salt solvent'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • General Boating Discussion
    • Boat Topics and Questions
    • Bottom Paint Discussions
  • Product Categories
    • Abrasives
    • Anchoring and Docking
    • Apparel
    • Cleaning and Polishing
    • Electrical
    • Electronics
    • Engine Room
    • Epoxy and Adhesives
    • Fasteners
    • Fiberglass Supplies
    • Fishing Tackle
    • Gifts and Books
    • Hand Tools
    • Hardware
    • Marine Supplies
    • Paints
    • Paint Supplies
    • Plumbing
    • Power Tools
    • Storage / Organization
    • Safety
    • Tapes
    • TotalBoat Products
    • Trailer Parts
    • Varnish - Frequently Asked Questions
    • Wood, Foam, Starboard

Found 1 result

  1. In a Cruising World article, it was stated, " On drives that have already been submerged in salt water, another hidden enemy lurks: soluble salts, which are invisible and tasteless. These microscopic particles cause premature paint-system failure and must be cleaned away before any epoxy or paint is applied. The trouble is, these particles are difficult to clean off. In fact, a typical boatyard pressure washer won’t remove them. Yanmar, for example, recommends both a test kit and a biodegradable neutralizing wash made by Chlor-rid Corporation (www.chlor-rid.com). If you’re recoating a saildrive, this step is super important to ensure that the coating stays on the aluminum." Chlor*Rid does not come in quantities that are useable for a saildrive application prior to applying an epoxy barrier except for a boatyard that does that work. Are there any other salt solvents available? One recommendation is sanding before the exp0oy starts to set up to assure adhesion. How about steam cleaning?