• Announcements

    • skiptabor

      The future of the JD Forum   07/31/18

      Thank you all for your participation on the JD Forums.  We have enjoyed answering your questions, providing project advice and technical assistance on this forum for a number of years. We believe that there are now better ways to provide this service for our customers and the community. With that in mind, we have made the difficult decision to discontinue the Jamestown Distributors Forum.   Our JD Tech Team is committed to being your trusted technical resource, and we encourage you to reach out via email, phone, social, product reviews, and to post questions using the Q & A 'Ask A Question' function on all product pages. Additional information can also be found on product page Technical Data Sheets (including detailed usage instructions and application data).   Thank You Jamestown Distributors 
cguyfish62

nylon washers...

7 posts in this topic

I am looking for off white countersunk nylon washers that have a hole for a #10 screw.

Also need the rubber inserts that go into windshields that have a flange on one end.

Thanks so much.

Share this post


Link to post
Share on other sites

Look at 

 
#10 
FNLFW10 FLAT WASHER NYLON #10 100/BX

 

ANC-760375 -- 1/4 inch Grommets 
ANC-760375

 

Grommets measure 1/4 in. diameter with a 3/8 in. hole and a panel width of 3/32. Sold in packs of 5.

Share this post


Link to post
Share on other sites

Thanks for getting back.

 

I am sending a pic of each.

The nylon washer needs to be BLACK.

The rubber grommet ( I can send measurement) fits into plexiglass windshield from the inside with the flange on the inside.

Also need the #8 or #10( not sure) x 1 1/4" stainless oval head phillip screws .

Also need the same screw with some of the countersunk stainless finish washers.

Could you send me a clickable link for each.

Thanks again Rick

cguyfish

post-3723-0-13200400-1440175835_thumb.jpg

post-3723-0-44956900-1440175836_thumb.jpg

Share this post


Link to post
Share on other sites

Thanks for getting back.

 

I am sending a pic of each.

The nylon washer needs to be BLACK.

The rubber grommet ( I can send measurement) fits into plexiglass windshield from the inside with the flange on the inside.

Also need the #8 or #10( not sure) x 1 1/4" stainless oval head phillip screws .

Also need the same screw with some of the countersunk stainless finish washers.

Could you send me a clickable link for each.

Thanks again Rick

cguyfish

Could you please send a link for each of these items..Thanks

Share this post


Link to post
Share on other sites