Sign in to follow this  
Followers 0
Jamie

What Primer to use

2 posts in this topic

   I have a 1987 38 ft Fiberglass boat that at some point in its life has had the transom banged up . I have repaired all the cracks and dings with fiberglass and Epoxy using Interlux watertite filler and faired smooth and ready to prime. I am going to use Interlux Perfection white above the water line . My question is since it has quite a few places on the transom , I was thinking of priming with Interlux Interprotect with 5 or 6 coats and sand smooth and apply the perfection above the water line only , I want to make sure it sealed up tight due to having to grind the gelcoat off in so many places, I would say a 1/4 of the transom has been repaired from damage and or crazing . Any and all thoughts are welcome  Thanks  Jamie

Share this post


Link to post
Share on other sites

The Interlux Perfection usually calls for the Epoxy Primekote but if you are covering repaired areas, the 2000E is a good choice and provide better protection in those areas.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0