• Announcements

    • skiptabor

      The future of the JD Forum   07/31/18

      Thank you all for your participation on the JD Forums.  We have enjoyed answering your questions, providing project advice and technical assistance on this forum for a number of years. We believe that there are now better ways to provide this service for our customers and the community. With that in mind, we have made the difficult decision to discontinue the Jamestown Distributors Forum.   Our JD Tech Team is committed to being your trusted technical resource, and we encourage you to reach out via email, phone, social, product reviews, and to post questions using the Q & A 'Ask A Question' function on all product pages. Additional information can also be found on product page Technical Data Sheets (including detailed usage instructions and application data).   Thank You Jamestown Distributors 
Cap'n Linwood

Roll and Tip AwlCraft for small areas?

3 posts in this topic

I plan to spray my cockpit and deck.  I would like to spray the hatches in place, then pull them up and roll and/or brush the support beams.  They are only visible when the hatches are open.  I did not want to tape off everything below decks to save time.  Can I do this touching up with a roller or brush, or just bite the bullet and tape them off and spray them.  They are the size of 2 by 4's, more or less, and it would save a lot of time.

Thanks!

Share this post


Link to post
Share on other sites

Technically you need to spray only with Awlcraft.  If you are only doing doing a real small area you can try to roll it with a foam roller and see how it comes out.

 

Cap'n Linwood likes this

Share this post


Link to post
Share on other sites