Sign in to follow this  
Followers 0
RickW

Teleflex Hydraulic Seal Kit For Outboard Cylinders

4 posts in this topic

KEVIN ENGLUND asked:
I am trying to replace the o rings but the diagram is not very clear on where they go.I see one set goes to the bleeder screw (2 o rings) but when I disconnect the hydraulic lines I don't see any o rings in line or anywhere on the fitting. are they just missing ? I don't see any other place for these o rings to go. any info would be greatly appreciated. my kit is hs 5157 and 5167.

Share this post


Link to post
Share on other sites
JORGE ALVAREZ:
I replace seals that screws into the cylinder housing,thats the seals that wears the most,because the in and out by turning,and lifting engine,i never needed the other seal in the kit.

Share this post


Link to post
Share on other sites
 PHILLIP LAWRENCE:
Kevin, I recently installed the HS5157 seal kit on my HC5345 pivot mount steering cylinder. Actually, all I did was to replace the two seal glands & bleed the lines. I did not even disconnect the two hydraulic lines. I just saved all the O rings for posterity. Hope this helps. Phillip

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0